This is a body off new frame project with extensive rustproofing. Every rubber part was replaced. All new key mechanicals as well from a new tank sender to a new fuel pump were done to new fuel cap. Plus new pistons and cylinders. New Burton Carburetor. The engine was extensively reworked by a professional race engine builder (runs unbelievably).

Points replaced by electronic. New top, newly upholstered seats, padding and carpet. All new door seals, window seals, etc. New heat pipes. Added blower motor to direct air from dash vent to the floor for better cooling air in the cabin and airflow vent added beneath the back seat for maximum flow through. Added rear defroster. Mounted rear bumper back up lights. All panels sanded to bare metal, professionally panel pounded to perfection before painting. Front clip assembled with stainless steel and rubber bushing to eliminate panels rubbing and vibration. Sandblasted rims, new Japanese tires and hubcaps. New windshield. All new turn signal light lenses. Rear window defroster. New steering wheel. Custom made ergonomic gas pedal rather than ankle aching version the vehicle came with. Additional rear hatch prop rod to prevent sagging when opened (not installed). And more… Plus all part receipts.

Needs only a little finishing on paint and interior assembly. New Front window gaskets on back-order from Burton. Many spare parts. Full shop manuals.

$16,000 or best offer. Located near Cleveland, OH. Contact Jeff Kanter, tel: 440-283-6849 or email to:

1 comment

  1. OK, it’s been a year with no takers. Have you got it back together in the meantime, or is it in the same state today?

Leave a Reply

Your email address will not be published. Required fields are marked *


Access further archives on our Archive Documents page.



A community of Citroën enthusiasts with a passion for Citroën automobiles.

Citroënvie © Copyright 2023. All rights reserved.